Nightscout with xDrip Wireless Bridge (Wixel)

17 Oct
Build an xDrip Wireless Bridge (Wixel) The xDrip Wireless Bridge is a DIY project in which you assemble and program an alternate CGM receiver that can be used to receive data from the Dexcom G4 transmitter. Once built, your xDrip...
Read more »

Alarms: How-To…

4 Aug
The Nightscout application has built in alarms to alert you when glucose levels are consistently below 80 or over 180.  One or two values above or below those limits will not trigger the alarm until consistent hi/low readings have been...
Read more »

Nightscout for FreeStyle Libre

26 Mar
(Thank you to Sarah Davies for assistance with directions and screenshots for this resource.) Using Nightscout with FreeStyle Libre To use Nightscout with FreeStyle® Libre, you will need the following: A working FreeStyle Libre system A working Nightscout site An...
Read more »

Nightscout and the Medtronic 600-series

25 Feb
Direct Nightscout access is now available in a beta release Android application for all of the Medtronic 600-series pumps. Users of the 630g, 640g and 670g pump should visit Lennart Goedhart’s 600-series Android Uploader page for up-to-date instructions on setup...
Read more »

MiniMed Connect and Nightscout

1 Nov
Set up MiniMed Connect with Nightscout on Azure By Mark Wilson This setup guide will enable you to bridge data from the MiniMed Connect into a Nightscout site running on Azure. If you use a Medtronic Enlite CGM, you will...
Read more »